The Tuning School GM LS & LT Standalone Tuning Using Holley Terminator X

5021

Are you ready to take control of your GM LS/LT build, while taking your knowledge to the next level of performance Holley Terminator X training from The Tuning School is here to help. Learn how to properly install and set up your Terminator X and Max devices, while also learning a safe and repeatable process for tuning.

Supported modifications for this course: heads/cam, bolt ons, and forced induction setups.

Course Topics:

• Basic Setup - Hardware
• Sensors and Actuators

• Software Operation
• Software Setup
• Datalogging Basics
• Critical Parameters Setup

• Tuning Topics (for N/A and Forced Induction combinations)
• Fuel Injector Sizing
• Engine Size
• Idle/Part Throttle Tuning
• Speedometer and Rear Gear Calibration
• Engine Cooling Controls
• Timing Table Updates
• Fuel Table Updates
• Airflow Table Updates
• WOT Tuning
• Drive by Wire Throttle Response
• Working with the Learn Table
• Target A/F Ratio
• Transmission Tuning

Supported Engines:

LS1/LS6, LS2/LS3, LS 24X 4.8/5.3/6.0 Trucks, LS 58X 4.8/5.3/6.0 Trucks, and Gen V LT applications.

Supported Transmissions:

4L60E and 4L80E (LS Specific) and 4L60 and 4L80 (LT Specific)